#
It is currently Fri Oct 24, 2014 3:40 am


Post a new topicPost a reply Page 1 of 1   [ 2 posts ]
Author Message
 Post subject: Adjusting valve backlash
PostPosted: Fri Jul 02, 2010 2:58 pm 

Joined: Sat Apr 03, 2010 9:36 am
Posts: 7
Location: washington state
Another Dumb question:

I've never adjusted the valves so I have a question.

On a '70 Datsun 2000 engine;

Do I need to trim down (Make narrower) my feeler gages to fit in the notch in the cap that the rocker rides on? I think it would be about 1/4 inch wide.

Any input would be helpful.

Thanks,
Oz


Top
 Profile  
 
 Post subject:
PostPosted: Fri Jul 02, 2010 4:32 pm 
User avatar

Joined: Sat Feb 10, 2007 5:23 pm
Posts: 297
Location: Napa Ca
The intakes are .008 and the exhausts are .010. You can get them close cold, then warm it up and recheck. I think you need a 14mm open end for the adjuster and a 19mm for the lock nut.
I start with the intakes, starting with #1 cyl (front of the engine) then go back and do the exhaust valves, again starting with #1.

Hopefully you don't have something odd going on where you need larger lash pads that fit under the rocker arm on top of the valve. If your wipe pattern is off, that will cause the cam and rockers to degrade at a very fast rate. An "A" or "B" cam or even a slightly larger cam should be fine.

Just make sure the valve is fully closed (cam lobe pointing up) and you should be good to go.

Will

_________________
1969 Datsun 2000 (track car, driven daily)
1959 Alfa Romeo 101.02 Sprint (big project)
1969 Alfa Romeo 105.51 GTV (R.I.P)
'87 BMW M3


Top
 Profile  
 
Display posts from previous:  Sort by  
Post a new topicPost a reply Page 1 of 1   [ 2 posts ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  


Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
610nm Style by Daniel St. Jules of Gamexe.net