#
It is currently Tue Sep 02, 2014 8:22 am


Post a new topicPost a reply Page 1 of 1   [ 1 post ]
Author Message
 Post subject: input/output shaft seal on w50 how to?
PostPosted: Sun May 19, 2013 5:32 pm 

Joined: Mon Feb 27, 2012 1:35 pm
Posts: 23
Location: Seattle
I'm prepping a w50 for install (first on my 18rc before i mate to my rg when its finished). I've been pouring over the manuals on RetroJDM but I can't get a clear idea on how you replace the input and output shaft seal.

1.) for the input shaft seal, I can't tell how to remove or replace it, it looks as if you need to remove the bell housing, but im not sure?
2.) if I do have to pull the bell housing, I'm guessing theres a gasket there that will need replaced, but It looks like its discontinued, that mean I need to make one?
3.) output shaft seal removal is a little clearer, but it looks like there is an SST involved, and i definately don't have that

any ideas?


Top
 Profile  
 
Display posts from previous:  Sort by  
Post a new topicPost a reply Page 1 of 1   [ 1 post ]


Who is online

Users browsing this forum: Jetto and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  


Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
610nm Style by Daniel St. Jules of Gamexe.net