I'm not sure man, I haven't looked at the rotors yet. Only to check the brakes, didn't pay much attention to how they'd come off. I've found a lot of similar things to the 323 though, so I reckon they'd be the same. Probably the same brakes.
You've heard stories of the wind in ones coming out?!?? How badly did this story go...?
not sounding too good..
The ones I found are only about $40 shipped. I mean, I don't see that there'd be much variation whether you pay $200 or $40, they'd have to be a certain tensile strength to hold the wheels on, no matter how much you pay.
Knock in studs seem loads better, but so much messing around, I'm not up for it, if there's an easier way.
The wheels on your 323 must have had a tapered seat in them, yeah?