Been busy with work and renovating the house but some parts arrived from Jesse Streeter in Japan today so into the garage I went.
Tein front strut brace - my one that came with the car was pretty rough.
And took a chance on a URAS triple duct too. Decided if it didn't fit some Skyline guy would buy it - but it fits! Just a little bit of die grinding on the ends to follow the profile of the bumper strip then I will paint it and stick it on.
I am painting it gloss black to match the gloss black RE Amemiya mirrors, RE Amemiya rear spoiler and the Work Rezax wheels. I wanted to break up the white a little and this balances out the rear spoier nicely. Need all the air through the front I can get - especially when a front mount goes on there later with the Cosmo motor I am looking to in a few years. For now it helps get that important air in.
I have just designed an offset plate bracket for the front I will fold up tomorrow out of alloy and install to move the plate to the right hand side of the bumper to max airflow on the street. Not an issue at the strack with the plates off...............
On a side note - if you need anything form import monster/ RHD Japan Jesse is great.
More going on with the car in the next few weeks. Hoping to fit up a lot more parts, tidy the nuts and bolt up with all new stuff and trim the doors.