Thought I'd finally share my project, on the factory built Rx7 race car replica, as raced in Daytona 1979 race. Using the MFR components found in the Rx7 Competition Preparation and Service manual. It been a long/hard/costly project so far, with many hours/days/years searching the web for parts.
Here are some shot of the cars being tested back in the day, on which my car will be painted with light and dark green stripes.
Those cars were powered by the MFR 12a PP engine and using all the MFR parts bin. The list of MFR parts is a long one, look here. Mazda Factory Race parts
Story so far, The Late Loen Prgomet started with my shell and install the new roll cage, rear control arm mounting to suit the longer MFR arms, drivers seat mount with cutting the floor (I'm a tall bastard), fuel tank and exhaust system. Once completed it was off to start the paint and panel.
Pic's of the cage and floor mod:
Back to bare metal....
Under coat and flares fit up....
Under car and engine bay in colour Aurora White (WN)
This is where the project is at and just waiting until the weather heats up for the rest to be painted and suspension is installed. Mind you about 400 hours worked on the body work so far, back to bare metal and rust repairs.
painted the cabin area. Flat black as the factory cars.