hi guys here is my ra45 gt with a full on race beams






last pic is how it is at the moment
weighs in total with steel cage etc 970 kilos
car has 310 mm rotors on front with ap4 spot calipers and 28mm thick vented
on the back are ap 4spots on on 20mm thick vented 280mm

By God that engineed is a piece of art...

_________________
77 TE51
86 AE86- need fenders, lights, rear bumper, Hood, seats, interior knobs.

Nice car. How much hp are you getting out of that beams?

its making 204 kws at the back wheels at 9200 rpm

Are those cams as big as they look?

yes the inlet is 565 thou and the exhaust cam is 530 thou plus im still using some vvti and in the pics you can see it has 2 stage fuel injection going through my 50mm quad throttles
all of the inlet and quad throttles i have made same with the 2stage as well
also make ti retainers for the new valve springs for the steel valves that i use
the only thing that is not changed on this motor is the block and head

What strut/coilover setup are you using?

ra45 strut with a small 65 mm dia spring and using bilstein shocks

I guess the better question is what are the rotors sourced from, and did you put any adapters to make the AP calipers fit on the strut?

front rotors are from a seirra cosworth race car ,and are from the rear end 28mm x315 as std ap rotor or harop rotor .
calipers are radial mount and uses a dog bone with alloy hat.
the rear of my car comes std with a 7.5 bango and has a alloy bracket bolted to the 3 axle bolts and rear calipers are lug mount,with another alloy hat bolted to the axle

pics of crank and pistons and rods

What sort of motor mounts and crossmember fabbing did you need to accomplish to facilitate dropping the BEAMS motor in??

KFD

bolted in a ta23 or ta40 crossmember in and used sa63 engine mounts

This thing is beast!

_________________

ok current pics of what it looks like at the moment and with both sets of te37/v as well





this is with the te37 normal wheels with 225 tyres on the back

i love the wideband bungs for each cylinder.. serious tuning.

_________________
I have a Metric S&!T ton of Datsun/Toyota parts pre 82 let me know if you need anything,

73 rb25 240z, body Bracing, cage, paint in progress.
78 Cressida Body, Paint, and 2jzgte in progress.

as these are the beams race pipes with the slip on fittings i have 2 do every cylinder ,to either add fuel or take out fuel on the cylinder table on the motec set up

This is incredible. I was looking at pictures of this very car online while I was looking for inspiration for my project! Glad to see it in greater detail, it just gets cooler by the minute.

_________________
-Cam
1980 Toyota Celica
1984 Porsche 911
1988 Mazda RX7

nice car!!

great tuning for the race!!!

nice looking racer

_________________