some new pics of various stuff
Roll center adjusters i just installed (some may install easier, but these required a little grinding to fit, but it was well worth it!
i bought an E-fan kit off the auctions a couple of years back and decided to throw it on the car a few weeks ago. i have my reasons. mostly because the car was running really hot on a mountain run i did a while back. the stock fan is tiny and didn't seem very efficient. only problem is no matter what temp sensor/switch i install, the damn thing will NOT work. i bought this switch from a local guy on base, and it works with a dummy switch and with a temp sensor. the rad is too thin for the temp sensor to get hot enough so i have to monitor the temperature closely and turn the switch on by hand.
im wondering if i buy a newer aluminum rad if it will work a bit better. theres not much clearance between the pulley and the rad so you have to install it offset a bit. it works really well so far. i just let the car warm up then throw the switch and leave the fan on. also you have to make sure its wired to pull air not push air (unless you put it in front of the rad which might be a smart move because of clearance issues)
here is a crappy pic showing how close the water pump pulley is to the fan.
that wire and silver piece you see over the pulley is the temp probe that came with the fan kit. i couldnt get it to work even with a heat gun, so im sure its shorted out. the auction didnt mention anything about it not working