Hi, could one of the US based guys with an N600 do me a favor and measure where the holes for the US spec bumper over riders (towl bars) bolt onto the front bumper for me, I'm going to fit them on my UK spec car and the bumper isn't drilled for them. figured I'd drill them now before they go for chroming.

essentially I need to work out how far from the rear edge of the bumper the holes are and say how far inboard the inner fixing is from the bumper bracket attachment.

thanks, just a few things to iron out and parts to source them my resto can begin

_________________
regards

Matt J..

www.team-dandism.co.uk

Might need to post a photo of what you're talking about.

Mine has these type bars on the front bumper. Is that what you're talking about?

Yep exactlty those, they only appear to be on some of the US spec vehicles.

I need to know where the inner mounting is relative to the bumper brackets and how far in from the edge of the bumper the hole is so that I can get the inner holes marked and drilled and then use the rail to define where the outer holes go, i presume these are on the curved wrap around section of the bumper so they'd be harder to tie down their position.

If you could measure the ones on your car it'd be very much appreciated.

_________________
regards

Matt J..

www.team-dandism.co.uk

If datsunfreak cant get you the details Pm me. I have the bumpers off on my car & should be too hard to get those specs for you.

_________________
http://www.HistoricJ.com

I won't be in a position to measure mine for a few weeks, so if you can get it done, please do.