finally got some days off to work on the Z...its been a while
all the siblings together..jealous of the Z inside lol
popped the windshield out to see if there was any rust...and there was haha, not too bad and nothing major thankfully
cleaaaan
just need a little more tlc and will be good to go
yes that is a bottle of metal ready haha
this hood is going bye bye if someone wants to buy it..got some rot in the front, and is being replaced with another one shortly
slaving away with more sanding action..whoo hoo..found out i had more rust on this sides lower rocker panel...so im going to cut out just replace both of them
mooorrreee work
hello im back again so dust doesnt go flying into the car
going to be tackling this awful mess tomorrow..it was covered in SUPER amounts of bondo..wtf
while i was picking up my other hood from being sand blasted i noticed some race miatas in the parking lot, pretty coool
mmmm mazdas
to work on my rear panel i have to pull the gas tank out, which needed to be done anyways
a lot better looking inside than what i thought it would be
going down!
OMG IM DIRTY!!
no rust above, just a bunch of scary spider webs
well i forgot to take pictures of the finished roof and pillars as well as my blasted hood. will post those up later.
in looking back through what ive done so far ive decided after cutting a few holes in the pass side floor..and doing a really crappy job welding pieces..that i am just going to replace the whole floor. im spending this much time on this and want to do it right. along with the floor i also have to replace a section of the frame rail directly under the batt tray too. all this will be tackled once i finish getting some primer/paint on the car.
till next time!
Damn cant wait to see it rolling on the streets lookin all badass. Now i just gotta convince Norcal510 to let me drive one of his skylines to an old school meet so i can be part of the cool kids!!!
Keep it up its gonna be roaming the streets scarfin up Skylines in no time!!!! HAHAHA
