#
It is currently Fri Oct 24, 2014 4:33 pm


Post a new topicPost a reply Page 1 of 1   [ 12 posts ]
Author Message
 Post subject: 67 Corona Help
PostPosted: Sat Jun 16, 2012 4:45 pm 
User avatar

Joined: Sat May 29, 2010 11:52 am
Posts: 100
Location: Springfield, OR
about a year ago my dads Rona died... While i was driving it. It wouldnt spark, turns out it was the ignition. So we switched that out and it still wont run.

Specs
Bone stock 3r-c with toyoglide 2 speed.

New Stuff.
Coil
Rotor
Cap
Plugs
Rebuilt Carb
Ignition Switch
Condenser

So heres the problem.
It will crank over, we have strong spark. It will keep cranking and it'll act like its going to start but it will never actually run. We are starting to get fed up with it and dont have a clue what to do. So im wondering if anyone can shed some light on this subject, Is this a common problem with these cars?


Top
 Profile  
 
 Post subject: Re: 67 Corona Help
PostPosted: Sat Jun 16, 2012 5:22 pm 
User avatar

Joined: Sat May 08, 2010 4:10 pm
Posts: 59
Location: California
You getting fuel? if you can't tell, pull the aircleaner off and drip a few drops of fresh clean gas down into the carb and see if it changes anything. just dont drop too much in there =p.


Top
 Profile  
 
 Post subject: Re: 67 Corona Help
PostPosted: Sat Jun 16, 2012 9:21 pm 
User avatar

Joined: Sat May 29, 2010 11:52 am
Posts: 100
Location: Springfield, OR
adamyee wrote:
You getting fuel? if you can't tell, pull the aircleaner off and drip a few drops of fresh clean gas down into the carb and see if it changes anything. just dont drop too much in there =p.


Already been tried. In the little peep hole on the side of the carb the level stays pretty much the same... if anything we are getting to much, but i doubt it.


Top
 Profile  
 
 Post subject: Re: 67 Corona Help
PostPosted: Sat Jun 16, 2012 9:23 pm 
User avatar

Joined: Sat May 29, 2010 11:52 am
Posts: 100
Location: Springfield, OR
asirike20 wrote:
surely there is a problem with the carb..........
maybe it is blocked..............


I dont think so because if i look through the butterflies i can see fuel at the bottom of the intake... :?
Could the intake get clogged somehow?


Top
 Profile  
 
 Post subject: Re: 67 Corona Help
PostPosted: Sat Jun 16, 2012 9:43 pm 

Joined: Fri Oct 23, 2009 9:52 am
Posts: 18
Location: Sacramento, CA
Check the timing??? I'm just sayin :tu:


Top
 Profile  
 
 Post subject: Re: 67 Corona Help
PostPosted: Sat Jun 16, 2012 9:50 pm 
User avatar

Joined: Sat May 29, 2010 11:52 am
Posts: 100
Location: Springfield, OR
Garlic Cruton wrote:
Check the timing??? I'm just sayin :tu:


Ah, that leads me to another dilema. The distributor does not move... no matter how hard I try and turn it(not trying too hard for fear of breaking it).
I'm assuming this is not normal but I'm not sure, I'm not to familiar with this engine.


Top
 Profile  
 
 Post subject: Re: 67 Corona Help
PostPosted: Sat Jun 16, 2012 11:23 pm 
User avatar

Joined: Sat May 08, 2010 4:10 pm
Posts: 59
Location: California
You are loosening the dizzy before you try and turn it right? Sorry if you take that wrong, but I've seen people try it before =P


Top
 Profile  
 
 Post subject: Re: 67 Corona Help
PostPosted: Sat Jun 16, 2012 11:30 pm 
User avatar

Joined: Sat May 29, 2010 11:52 am
Posts: 100
Location: Springfield, OR
adamyee wrote:
You are loosening the dizzy before you try and turn it right? Sorry if you take that wrong, but I've seen people try it before =P


Yes sir, Small clamp just under the dizzy holding to the block.


Top
 Profile  
 
 Post subject: Re: 67 Corona Help
PostPosted: Sat Jun 16, 2012 11:41 pm 
User avatar

Joined: Sat May 08, 2010 4:10 pm
Posts: 59
Location: California
and the thing wont budge at all? does it still slide out of the block?


Top
 Profile  
 
 Post subject: Re: 67 Corona Help
PostPosted: Sun Jun 17, 2012 7:49 am 
User avatar

Joined: Sat May 29, 2010 11:52 am
Posts: 100
Location: Springfield, OR
adamyee wrote:
and the thing wont budge at all? does it still slide out of the block?


I haven't tried to take it out, but no, it doesn't budge when turning.
:cry:


Top
 Profile  
 
 Post subject: Re: 67 Corona Help
PostPosted: Sun Jun 17, 2012 11:33 am 
User avatar

Joined: Sat May 08, 2010 4:10 pm
Posts: 59
Location: California
I doubt thats your problem, but it is a problem in itself =p.


Top
 Profile  
 
 Post subject: Re: 67 Corona Help
PostPosted: Mon Jun 18, 2012 9:22 am 
User avatar

Joined: Sat May 29, 2010 11:52 am
Posts: 100
Location: Springfield, OR
adamyee wrote:
I doubt thats your problem, but it is a problem in itself =p.


I will be attempting to take the dizzy out this week so i should hopefully get some answers... :tu:


Top
 Profile  
 
Display posts from previous:  Sort by  
Post a new topicPost a reply Page 1 of 1   [ 12 posts ]


Who is online

Users browsing this forum: No registered users and 4 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  


Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
610nm Style by Daniel St. Jules of Gamexe.net