#
It is currently Thu May 23, 2013 5:28 pm


Post a new topicPost a reply Page 1 of 2   [ 21 posts ]
 Go to page 1, 2  Next
  Print view Previous topic | Next topic 
Author Message
Hitman Cody2130
 Post subject: FB on diamond racing wheels?
PostPosted: Fri Dec 24, 2010 10:35 am 

Joined: Thu Dec 23, 2010 6:10 am
Posts: 98
Location: Washington State
I was having a hell of a time finding low offset 15x8+ wheels in 4x110, found diamond racing wheels on line and found out that they drill 4x110 :) I am about to pull the trigger and for ~100 bucks a wheel they seem like a great deal. Anyone on here used them on an fb or any other car for that matter?
Top
 Profile  
 
john
 Post subject:
PostPosted: Fri Dec 24, 2010 1:50 pm 
Moderator
User avatar

Joined: Fri Oct 12, 2007 8:57 pm
Posts: 8679
Location: Fort Worth, TX, USA
Lots of guys on here have used them on other cars. Never seen them on an RX7 though. Well, at least not on an RX7 that wasn't a dirt track racer... :P

My dream car, belonged to a member here:

Image
Top
 OnlineProfile  
 
boxerpicker
 Post subject:
PostPosted: Sat Dec 25, 2010 11:50 pm 

Joined: Sun Oct 24, 2010 10:24 pm
Posts: 86
Location: NW Washington
im going to get diamonds for my SA too but you could swap gsl-se rear end they have better brakes, lsd and 4x114
Top
 Profile  
 
Hitman Cody2130
 Post subject:
PostPosted: Sun Dec 26, 2010 1:36 pm 

Joined: Thu Dec 23, 2010 6:10 am
Posts: 98
Location: Washington State
Yeah, honestly the diamonds are just a temp setup till I swap to T2 brakes, 5x114.3 and a better axle with a good lsd.
Top
 Profile  
 
sarinas_dragons
 Post subject: /diamonds
PostPosted: Sun Dec 26, 2010 3:58 pm 

Joined: Sun Jan 31, 2010 3:18 pm
Posts: 75
Location: Parkland, WA
Take a look at Bassets, too

Instead of 10 spoke I think they're 8...

...what did yo see on race-cars.com?
Top
 Profile  
 
Hitman Cody2130
 Post subject:
PostPosted: Sun Dec 26, 2010 10:34 pm 

Joined: Thu Dec 23, 2010 6:10 am
Posts: 98
Location: Washington State
I'll check those out, couldnt find anything on race-cars.com
Top
 Profile  
 
ewokracing
 Post subject:
PostPosted: Mon Dec 27, 2010 12:34 am 

Joined: Mon Jun 08, 2009 9:26 pm
Posts: 651
Location: Melbourne, Australia
datsunfreak wrote:
Lots of guys on here have used them on other cars. Never seen them on an RX7 though. Well, at least not on an RX7 that wasn't a dirt track racer... :P

My dream car, belonged to a member here:

Image


I salute you datsun freak and your fine taste in automobiles.

We only got the sedan versions of these here in oz, but I have a sneaking suspicion that coupe and wagon variants exist? a friend of mine did a few road trips in one, comfy cruising, just needed a bit more power for hills and overtaking.
Top
 Profile  
 
john
 Post subject:
PostPosted: Mon Dec 27, 2010 6:24 pm 
Moderator
User avatar

Joined: Fri Oct 12, 2007 8:57 pm
Posts: 8679
Location: Fort Worth, TX, USA
ewokracing wrote:
We only got the sedan versions of these here in oz, but I have a sneaking suspicion that coupe and wagon variants exist?


Yup. :tu:

Only sedans and wagons here in the US, but lots of markets got the coupe.
Top
 OnlineProfile  
 
B1500boy
 Post subject:
PostPosted: Mon Dec 27, 2010 11:14 pm 
User avatar

Joined: Tue Jan 15, 2008 3:40 am
Posts: 903
Location: Villeneuve, Qld, Australia
I agree with you there DF, that is hot!

Ewok, here's one coupe up here in QLD, a good friend owns it

Image

_________________
Too many Mazda's in the collection. 4 Mitsubishi's, 6 Toyota's and now 3 Datsun's as well.
Putting together a Mazda/Japanese motor museum. New bigger venue for the museum has been bought, watch this space!
Top
 Profile  
 
john
 Post subject:
PostPosted: Tue Dec 28, 2010 6:29 pm 
Moderator
User avatar

Joined: Fri Oct 12, 2007 8:57 pm
Posts: 8679
Location: Fort Worth, TX, USA
FC on Diamonds? Is that close enough? :P

Image
Top
 OnlineProfile  
 
john
 Post subject:
PostPosted: Tue Dec 28, 2010 6:33 pm 
Moderator
User avatar

Joined: Fri Oct 12, 2007 8:57 pm
Posts: 8679
Location: Fort Worth, TX, USA
Crap fitment, but...

Image
Top
 OnlineProfile  
 
john
 Post subject:
PostPosted: Tue Dec 28, 2010 6:35 pm 
Moderator
User avatar

Joined: Fri Oct 12, 2007 8:57 pm
Posts: 8679
Location: Fort Worth, TX, USA
One more FC...

Image
Top
 OnlineProfile  
 
DeRuX
 Post subject:
PostPosted: Tue Dec 28, 2010 7:55 pm 

Joined: Wed Sep 26, 2007 9:04 am
Posts: 437
Location: Newark, CA
I think it will be ok. Now if datsunfreak can find a hako on some diamonds.
Top
 Profile  
 
john
 Post subject:
PostPosted: Wed Dec 29, 2010 5:14 pm 
Moderator
User avatar

Joined: Fri Oct 12, 2007 8:57 pm
Posts: 8679
Location: Fort Worth, TX, USA
DeRuX wrote:
Now if datsunfreak can find a hako on some diamonds.


You actually think someone's got the balls to do that? :P

With your car, I don't imagine it would look a lot different in principle than the Cressida shown above. :tu:

It would be dope. But the Hako Yakuza might disapprove... :mrgreen:
Top
 OnlineProfile  
 
Camshaft
 Post subject:
PostPosted: Wed Dec 29, 2010 5:23 pm 
Mild Cam
User avatar

Joined: Wed Feb 10, 2010 2:31 pm
Posts: 1600
Location: Cleveland, Ohio
That FC is teh hotness, even with the Dale Earnhardt Specials. 8)

_________________
-Cam
1988 Mazda RX7
1980 Toyota Celica
a bunch of cool other cars I'm not allowed to list
Image
Top
 Profile  
 
john
 Post subject:
PostPosted: Wed Dec 29, 2010 5:49 pm 
Moderator
User avatar

Joined: Fri Oct 12, 2007 8:57 pm
Posts: 8679
Location: Fort Worth, TX, USA
DeRuX wrote:
if datsunfreak can find a hako on some diamonds.


If you can't find it, fake it... :P

Image
Top
 OnlineProfile  
 
john
 Post subject:
PostPosted: Wed Dec 29, 2010 8:26 pm 
Moderator
User avatar

Joined: Fri Oct 12, 2007 8:57 pm
Posts: 8679
Location: Fort Worth, TX, USA
And for Derux... :twisted:

Image
Top
 OnlineProfile  
 
DeRuX
 Post subject:
PostPosted: Wed Dec 29, 2010 8:41 pm 

Joined: Wed Sep 26, 2007 9:04 am
Posts: 437
Location: Newark, CA
See I am telling you !!!
Top
 Profile  
 
Buzz3n
 Post subject:
PostPosted: Mon Jan 10, 2011 1:24 am 
User avatar

Joined: Mon Oct 12, 2009 3:37 pm
Posts: 66
Location: Australia
yes its been done,

yes it looks good

yes you should do it


now !


http://stanceworks.com/forums/showthread.php?t=9437

Image
Top
 Profile  
 
rx-7fd3s
 Post subject:
PostPosted: Sat Feb 05, 2011 6:57 pm 
User avatar

Joined: Sat Feb 21, 2009 4:35 pm
Posts: 34
Location: NORWAY
anyone know what kind of size/offset/backspacing i could use on my rx4 wagon?
thinking of getting a set in stain black powdercoat(with a red pinstripe)
i want them as "deepdish" as possible
Top
 Profile  
 
Display posts from previous:  Sort by  
Post a new topicPost a reply Page 1 of 2   [ 21 posts ]
 Go to page 1, 2  Next


Who is online

Users browsing this forum: No registered users and 2 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  


Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
610nm Style by Daniel St. Jules of Gamexe.net