#
It is currently Wed Jul 30, 2014 10:54 am


Post a new topicPost a reply Page 1 of 1   [ 2 posts ]
Author Message
 Post subject: Re-Drilling wheels from 4x114.3 to 4x110 Stud Pattern?
PostPosted: Sat Dec 10, 2011 1:57 am 

Joined: Thu Oct 01, 2009 8:00 pm
Posts: 31
Location: Australia
I've been looking for some 14x7" Enkei Cross Fevers for my RX-4, which has a 4x110 stud pattern, and the few wheels I have found are always 4x114.3.

There appears to be plenty of meat to do this, I assume the fill the existing hole with some kind of bung and then re-drill the holes to the new stud pattern.

Has anyone had their wheels modified from one stud pattern to another, and does anyone know a good place to get this done in Sydney, Australia?


Top
 Profile  
 
 Post subject: Re: Re-Drilling wheels from 4x114.3 to 4x110 Stud Pattern?
PostPosted: Sat Dec 10, 2011 5:22 pm 

Joined: Wed Mar 11, 2009 6:09 pm
Posts: 589
Location: Australia
I'm going to have this done to my wat's.$40 a wheel down in vic. Neales do it as well in Sydney for 75 a rim. They redrill and use an offset plug with a new hole position.114 to 110 is fine, anything outside of that range will cause you trouble. If there is lots of metal like you said you should be fine.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post a new topicPost a reply Page 1 of 1   [ 2 posts ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  


Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
610nm Style by Daniel St. Jules of Gamexe.net