Ugh.... all updates lost -__________-
Bummer I know. I just did a pic dump, could not be bothered with the words... Hope you'll start again! Neko.Originally Posted by longlivekel
Shame to see the thread reset.
How clean is that shell without clothes. Good score..
I have found some rust here and there. But nothing that scares me. The worse is the passenger rear door.
There is a small rust spot in the floor and a couple small spots here and there.. As i said... Its nothing I can't handle.
Here is a pic of the floor pan.
Here is a pic for your guys viewing pleasure :P
So last night I got my first panel in. I cut out the area where the drain holes were on the driver side. It was pretty rusty. I reproduced the panel and got it welded in.
The slag on the right was factory. A guy at my work commented on that and said i did a Sh.t job. So i got onto him about not knowing how to do metal fab and how he owns a POS mustang that he paid way too much cash for : P
Also.. last weekend i found a cool inventive way to get the underside of the car. It is so light that I lift and lean the car over with one hand using the door hinge as a handle. I then rest the opposing side's door handle onto a jack stand. : P
Space! Ahhh... to have space. Great stuff! Looks really neat.
you sandblasted the shell i'm guessing? Either way must of took a bit of time! Good stuff mate, love your builds
I used chemical stripper, paint stripping disks, and coal slag blasting to strip all of the car down to bare.